Adcon A720 Guide de l'utilisateur télécharger pdf (Page 29)

CHAPTER 2

Installation

To configure the modem parameters, click the Modem tab, and

then select from the combo box the modem you want to

configure. Following is a description of all configurable parameters

and their meaning (see Figure 9):

1. In the Dial section, you can configure either Tone (default) or

Pulse dialling. Most networks use tone dialling, but if in

doubt, ask your telephone provider.

2. If required, enter a Dialing prefix; this is mostly needed when

your gateway is connected to a private telephone exchange

(e.g. a leading “0” before dialing).

3. The Advanced options section allows you to change:

a. The Initialization command: the default should be

sufficient for most situations; however, you may need to

add other modem commands depending on your

particular environment. For more details consult the AT

command set specification.

Note: If you have a “Worldmodem” built-in your gateway, then

remove the “%TCB” command from the initialization

command. The information on your built-in modem is

provided in a leaflet included in the A840 package. In case

of doubt, please consult your dealer.

Figure 9. Modem parameters

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 145 146

Pas de commentaire

Adcon A720 Guide de l'utilisateur Page 29